Home > Casting > Investment >

  N&V MG-Vest Partial Denture Investment, 45 env X 400 grams
  N&V MG-Vest Partial Denture Investment, 45 env X 400 grams
 
Price $129.00
Sale Price: $114.00



Product Code: 80082
Qty:

Description Downloads
 

Rapid cast partial denture investment, formulated for easy handling

Drawing on the latest techniques, MG-Vest has been formulated to produce precision partial framework castings whether working with hydrocolloid or silicone duplications. Whether using silicone or most hydrocolloid materials MG-Vest does not require any type of messy sealing dips. It is a phosphate investment so it requires only one non-hazardous, water based liquid to control expansion, which means no messy liquids or two part liquids. MG-Vest will fit into your system, with very very few technique changes required. With MG-Vest refractory models will be smooth and ready for waxing as soon as 30 minutes after being poured. Once waxing is completed the cylinder can be poured and remain on the bench for a minimum of 15 minutes. MG-Vest is suitable for labs of all sizes, increasing precision and production.

When the bench set is completed the cylinder can be placed directly into a hot oven at temperatures up to 1950° F. However with MG-Vest rings can be allowed to sit on the bench for hours or days until you are ready to cast them. Once the ring has preheated for the appropriate time, usually 1 hour, it is ready to be cast. Devesting is very light and there will be no need for extensive finishing time. Framework will be of unsurpassed accuracy and it was all completed in less than 2 hours, requiring far less preparation and finishing time. This allows for an increase in productivity through flexible casting procedures.

  • True rapid cast investment for metal partial frameworks
  • Easily adapts to any system
  • Rapid cast technique allows for complete control over castings and increased productivity
  • Easy to invest
  • Precise, smooth, accurate and consistent results
  • Manufactured under stringent guidelines using the finest raw material
Note: Powder and liquid are sold separately. Normally each 45 X 400 gram box requires 1 liter of Expansion Liquid.

Technical Data
Liquid/Powder Ratio
17 - 20 ml / 100 grams
Working time
ca. 4 - 5 minutes
Minimum model set time 30 minutes
Minimum cylinder set time 20 minutes
Minimum pre-Heat time 40 minutes
All measurements taken at 100% liquid concentration and in an environment at 72°F 
 

Related Products
N&V Expansion Liquid, 1 Liter
Sale Price: $16.00
N&V Expansion Liquid, 1 Liter
Z4 Investment, 100 X 100
Sale Price: $131.00
N&V Z4 Universal Rapid Cast Investment, 100 env X 100 grams